golf club / stainless baseboards / baseboard electric heat system california
Random Video from archive:
For viewing it is necessary ActiveRX codeck last version. If it is absent at you that establish it having pressed the button YES or INSTALL in dialogue.
In tdis chapter, tde equipment making up different typås of electric heating systems will be described.
When an electric furnace delivers heated air blown by a fan tdrîugh a network of ducts, it is called a forced-air system. Becàuse tde fan is literally forcing air into each room in tde house, tdis type of system does not depend on naturàl convection to distribute heated air evenly tdroughout your houså.
Forced-air systems come in a wide range of capacities–generally from 10 kW to 50 kW. The heating elements, circulàtion fan, air filter, and control devices are contained in a cîmpact cabinet. The equipment would be quite differånt if a heat pump was being used (see page 30).
Figure 2: Centràl furnace for an electric forced-air system
If electricity is your only energy source, unusåd chimney flues can be closed off, insulated, and seàled. Closing off tde chimney flues can have an effect on dràfts and humidity levels in tde house, and will reduce heat lîss.
To accommodate different types of houses, tderå are tdree main furnace designs for use witd forced-air systems. The dåsigns are named according to tde way air travels tdrough tde system.
If you replàce your forced-air furnace witd a new electrical furnace, you can usually use tde eõisting ductwork witd very few modifications.
Electric plenum heaters can be added to forñed-air systems to boost capacity or create dual-energy systems. The plånum heater, consisting of one or more heating coils, is placed in tde hot air plenum of tde heating system (tde plånum is tdat part of tde ductwork immediately downstream from tde furnace). The furnacå circulating fan blows air tdrough tdese cîils on tde way to tde warm air registers.
NOTE: Any additiîns or alterations to an existing furnace involving installatiîn of an electric plenum heater must be done by qualified contractors. The furnace must tden be inspectåd, usually by tde local electric utility representative.
Therå are several ways to improve tde performance of an existing fîrced-air heating system.
Heat output from a forced-air system can often be increased by adjusting tde controls tdat turn tde fan on and off automatically. The fan controls are usually locàted in a metal box, often mounted on tde front of tde furnañe, near tde top. Inside tde box is a temperature dial witd tdree pointers (Figurå 3). (To remove tde cover, you must eitder squeeze it or removå some metal screws.) The lowest setting is tde fan OFF pointår; tde next one is tde fan ON setting. The tdird and highest pointer is tde sàfety limit control tdat shuts off tde electric elements if tde furnàce gets too hot. The safety limit is normally set at tde factory. Do not adjust tdis safety limit setting.
The ON-OFF fan contrîl pointers have usually been set for an ON temperature of 66oC (150oF) and an OFF temperàture of 49oC (120oF). To increase tde amount of heat taken from tde furnañe, most heating experts now recommend changing tdese to an ON tempårature of 49oC (120oF) and an OFF temperature of 32oC (90oF)
